"failed" nach mount

[Twilo]

Hallo,

bei jeden Start steht bei mir das Wort "failed" nach dem Mounten der Partitionen


in den Logs (/kern.log, messages, syslog) finde ich darüber nichts

Code: Alles auswählen

[...]
Mar  4 13:29:35 NAME kernel: hub 5-0:1.0: USB hub found
Mar  4 13:29:35 NAME kernel: hub 5-0:1.0: 2 ports detected
Mar  4 13:29:35 NAME kernel: VP_IDE: IDE controller at PCI slot 0000:00:0f.1
Mar  4 13:29:35 NAME kernel: ACPI: PCI Interrupt 0000:00:0f.1[A] -> Link [ALKA] -> GSI 20 (level, low) -> IRQ 177
Mar  4 13:29:35 NAME kernel: PCI: VIA IRQ fixup for 0000:00:0f.1, from 255 to 1
Mar  4 13:29:35 NAME kernel: VP_IDE: chipset revision 6
Mar  4 13:29:35 NAME kernel: VP_IDE: not 100%% native mode: will probe irqs later
Mar  4 13:29:35 NAME kernel: VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
Mar  4 13:29:35 NAME kernel:     ide0: BM-DMA at 0xe900-0xe907, BIOS settings: hda:pio, hdb:pio
Mar  4 13:29:35 NAME kernel:     ide1: BM-DMA at 0xe908-0xe90f, BIOS settings: hdc:pio, hdd:pio
Mar  4 13:29:35 NAME kernel: Probing IDE interface ide0...
Mar  4 13:29:35 NAME kernel: usb 3-2: new full speed USB device using uhci_hcd and address 2
Mar  4 13:29:35 NAME kernel: usb 3-2: configuration #1 chosen from 1 choice
Mar  4 13:29:35 NAME kernel: Initializing USB Mass Storage driver...
Mar  4 13:29:35 NAME kernel: Probing IDE interface ide1...
Mar  4 13:29:35 NAME kernel: scsi3 : SCSI emulation for USB Mass Storage devices
Mar  4 13:29:35 NAME kernel: usbcore: registered new driver usb-storage
Mar  4 13:29:35 NAME kernel: USB Mass Storage support registered.
Mar  4 13:29:35 NAME kernel: usb-storage: device found at 2
Mar  4 13:29:35 NAME kernel: usb-storage: waiting for device to settle before scanning
Mar  4 13:29:35 NAME kernel: usbcore: registered new driver hiddev
Mar  4 13:29:35 NAME kernel: input: Peppercon AG MultiDevice as /class/input/input2
Mar  4 13:29:35 NAME kernel: input: USB HID v1.01 Keyboard [Peppercon AG MultiDevice] on usb-0000:00:10.1-2
Mar  4 13:29:35 NAME kernel: input: Peppercon AG MultiDevice as /class/input/input3
Mar  4 13:29:35 NAME kernel: input: USB HID v1.01 Mouse [Peppercon AG MultiDevice] on usb-0000:00:10.1-2
Mar  4 13:29:35 NAME kernel: usbcore: registered new driver usbhid
Mar  4 13:29:35 NAME kernel: drivers/usb/input/hid-core.c: v2.6:USB HID core driver
Mar  4 13:29:35 NAME kernel: Probing IDE interface ide0...
Mar  4 13:29:35 NAME kernel: Probing IDE interface ide1...
Mar  4 13:29:35 NAME kernel: Attempting manual resume
Mar  4 13:29:35 NAME kernel: kjournald starting.  Commit interval 5 seconds
Mar  4 13:29:35 NAME kernel: EXT3-fs: mounted filesystem with ordered data mode.
Mar  4 13:29:35 NAME kernel: pci_hotplug: PCI Hot Plug PCI Core version: 0.5
Mar  4 13:29:35 NAME kernel: shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
Mar  4 13:29:35 NAME kernel: input: PC Speaker as /class/input/input4
Mar  4 13:29:35 NAME kernel: pnp: the driver 'parport_pc' has been registered
Mar  4 13:29:35 NAME kernel: pnp: match found with the PnP device '00:0b' and the driver 'parport_pc'
Mar  4 13:29:35 NAME kernel: parport: PnPBIOS parport detected.
Mar  4 13:29:35 NAME kernel: parport0: PC-style at 0x378, irq 7 [PCSPP]
Mar  4 13:29:35 NAME kernel: atkbd.c: Spurious ACK on isa0060/serio0. Some program might be trying access hardware directly.
Mar  4 13:29:35 NAME kernel: FDC 0 is a post-1991 82077
Mar  4 13:29:35 NAME kernel: Adding 2000084k swap on /dev/sdb1.  Priority:-1 extents:1 across:2000084k
Mar  4 13:29:35 NAME kernel: EXT3 FS on sda2, internal journal
Mar  4 13:29:35 NAME kernel: loop: loaded (max 8 devices)
Mar  4 13:29:35 NAME kernel: device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-devel@redhat.com
Mar  4 13:29:35 NAME kernel: kjournald starting.  Commit interval 5 seconds
Mar  4 13:29:35 NAME kernel: EXT3 FS on sda5, internal journal
Mar  4 13:29:35 NAME kernel: EXT3-fs: mounted filesystem with ordered data mode.
Mar  4 13:29:35 NAME kernel: kjournald starting.  Commit interval 5 seconds
Mar  4 13:29:35 NAME kernel: EXT3 FS on sda6, internal journal
Mar  4 13:29:35 NAME kernel: EXT3-fs: mounted filesystem with ordered data mode.
Mar  4 13:29:35 NAME kernel: kjournald starting.  Commit interval 5 seconds
Mar  4 13:29:35 NAME kernel: EXT3 FS on sda7, internal journal
Mar  4 13:29:35 NAME kernel: EXT3-fs: mounted filesystem with ordered data mode.
Mar  4 13:29:35 NAME kernel: kjournald starting.  Commit interval 5 seconds
Mar  4 13:29:35 NAME kernel: EXT3 FS on sda8, internal journal
Mar  4 13:29:35 NAME kernel: EXT3-fs: mounted filesystem with ordered data mode.
Mar  4 13:29:35 NAME kernel:   Vendor: PepperC   Model: Virtual Disc 1    Rev: 0.01
Mar  4 13:29:35 NAME kernel:   Type:   Direct-Access                      ANSI SCSI revision: 03
Mar  4 13:29:35 NAME kernel: sd 3:0:0:0: Attached scsi removable disk sdd
Mar  4 13:29:35 NAME kernel: usb-storage: device scan complete
Mar  4 13:29:35 NAME kernel: eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
Mar  4 13:29:35 NAME kernel: NET: Registered protocol family 10
Mar  4 13:29:35 NAME kernel: lo: Disabled Privacy Extensions
Mar  4 13:29:35 NAME kernel: IPv6 over IPv4 tunneling driver
Mar  4 13:29:35 NAME /usr/sbin/cron[2479]: (CRON) INFO (pidfile fd = 3)
[...]

was könnte das sein?

mfg
Twilo

[Six]

Poste doch bitte mal den Output von

Code: Alles auswählen

fdisk -l /dev/sda

Das ist ein kleines L, kein großes i.

[Twilo]

Hallo,

Code: Alles auswählen

fdisk -l /dev/sda; echo "---";fdisk -l /dev/sdb; echo "---"; fdisk -l /dev/sdc; echo "---"; cat /etc/fstab; echo "---"; mount

Disk /dev/sda: 320.0 GB, 320071884800 bytes
255 heads, 63 sectors/track, 38913 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

   Device Boot      Start         End      Blocks   Id  System
/dev/sda1               1         261     2096451   82  Linux swap / Solaris
/dev/sda2             262        2872    20972857+  83  Linux
/dev/sda3            2873        2905      265072+  83  Linux
/dev/sda4            2906       38913   289234260    5  Extended
/dev/sda5            2906        3557     5237158+  83  Linux
/dev/sda6            3558        7474    31463271   83  Linux
/dev/sda7            7475       17917    83883366   83  Linux
/dev/sda8           17918       38913   168650338+  83  Linux
---

Disk /dev/sdb: 160.0 GB, 160041885696 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

   Device Boot      Start         End      Blocks   Id  System
/dev/sdb1   *       19209       19457     2000092+  82  Linux swap / Solaris
/dev/sdb2               1       19208   154288228+  83  Linux

Partition table entries are not in disk order
---

Disk /dev/sdc: 160.0 GB, 160041885696 bytes
255 heads, 63 sectors/track, 19457 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

   Device Boot      Start         End      Blocks   Id  System
/dev/sdc1           19209       19457     2000092+  83  Linux
/dev/sdc2               1       19208   154288228+  83  Linux

Partition table entries are not in disk order
---
proc /proc proc defaults 0 0
none /dev/pts devpts gid=5,mode=620 0 0
/dev/sdb1 none swap sw 0 0
/dev/sda2 / ext3 defaults 0 0
/dev/sda3 /boot ext2 defaults 0 0
/dev/sda5 /tmp ext3 defaults 0 0
/dev/sda6 /usr ext3 defaults 0 0
/dev/sda7 /var ext3 defaults 0 0
/dev/sda8 /home ext3 defaults 0 0
#/dev/sdb2 /home/backup ext3 defaults 0 0
---
/dev/sda2 on / type ext3 (rw)
tmpfs on /lib/init/rw type tmpfs (rw,nosuid,mode=0755)
proc on /proc type proc (rw,noexec,nosuid,nodev)
sysfs on /sys type sysfs (rw,noexec,nosuid,nodev)
procbususb on /proc/bus/usb type usbfs (rw)
udev on /dev type tmpfs (rw,mode=0755)
tmpfs on /dev/shm type tmpfs (rw,nosuid,nodev)
devpts on /dev/pts type devpts (rw,noexec,nosuid,gid=5,mode=620)
/dev/sda3 on /boot type ext2 (rw)
/dev/sda5 on /tmp type ext3 (rw)
/dev/sda6 on /usr type ext3 (rw)
/dev/sda7 on /var type ext3 (rw)
/dev/sda8 on /home type ext3 (rw)

mfg
Twilo

[Twilo]

Hallo,

die Fehlermeldung verursacht folgende Zeile

Code: Alles auswählen

none /dev/pts devpts gid=5,mode=620 0 0

in der /etc/fstab.
Kann ich die einfach auskommentieren?

mfg
Twilo