kriege einfach meine Netzwerkkarte nicht zum laufen
lspci|grep I219
00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (17) I219-V (rev 11)
ip a
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host noprefixroute
valid_lft forever preferred_lft forever
2: wlx5c628b252135: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 5c:62:8b:25:21:35 brd ff:ff:ff:ff:ff:ff
inet 192.168.178.38/24 brd 192.168.178.255 scope global dynamic noprefixroute wlx5c628b252135
valid_lft 863779sec preferred_lft 863779sec
inet6 2a0a:a543
0:b345:7393
6c8f/64 scope global dynamic noprefixroute valid_lft 6442sec preferred_lft 2842sec
inet6 fe80::5fd:a3aa:a5c5:b819/64 scope link noprefixroute
valid_lft forever preferred_lft forever
uname -a
Linux LMDE 6.1.0-18-amd64 #1 SMP PREEMPT_DYNAMIC Debian 6.1.76-1 (2024-02-01) x86_64 GNU/Linux
Hier das aus dem log:
Mär 07 16:31:40 LMDE kernel: e1000e: Intel(R) PRO/1000 Network Driver
Mär 07 16:31:40 LMDE kernel: e1000e: Copyright(c) 1999 - 2015 Intel Corporation.
Mär 07 16:31:40 LMDE kernel: e1000e 0000:00:1f.6: enabling device (0000 -> 0002)
Mär 07 16:31:40 LMDE kernel: e1000e 0000:00:1f.6: Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
Mär 07 16:31:40 LMDE kernel: e1000e 0000:00:1f.6: The NVM Checksum Is Not Valid
Mär 07 16:31:40 LMDE kernel: e1000e: probe of 0000:00:1f.6 failed with error -5