Obwohl ich mit iwconfig den Device sehe:
Code: Alles auswählen
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11bg ESSID:"" Nickname:""
Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:54 Mb/s Tx-Power:24 dBm
Retry min limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Managementmode:All packets received
Link Quality=5/5 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Hier unterlege ich noch meine lsmod:
![NoPaste-Eintrag](./ext/phpbbde/pastebin/styles/debianforumde/theme/images/icon_pastebin.gif)
Installiert habe ich nach folgender Anleitung:
http://wiki.debian.org/wl#Broadcom (alle Punkte durch).
Was mir noch merkwrdig aufflt, dass in /etc/modprobe.d/broadcom-sta-common.conf seltsame Eintrge sind:
Code: Alles auswählen
# wl module from Broadcom conflicts with ssb
# We must blacklist the following modules:
blacklist b44
blacklist b43legacy
blacklist b43
blacklist ssb
install wl /sbin/modprobe --ignore-install wl $CMDLINE_OPTS
blacklist brcm80211
Ich habe: BCM4312 802.11b/g (rev 01).
Mit Gr., Gennadiy
Edit0: einfach eth1 in wicd-Konfiguration eintragen ...