Alles ok, bis vor kurzem ein "Ticken" hörbar wurde, ähnlich einem MorseZeichen!
Mit einem apt-get update wurde es unterbrochen, setzte nacher sofort wieder ein und zwar mit kleinen stop/go Unterbrüchen.
in kern.log sah in keine info
Thx
Code: Alles auswählen
shogun2:~# smartctl --all /dev/hdc
smartctl version 5.38 [i686-pc-linux-gnu] Copyright (C) 2002-8 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Model Family: Hitachi Travelstar 5K80 family
Device Model: HTS548080M9AT00
Serial Number: MRL442L4HB949B
Firmware Version: MG4OA53A
User Capacity: 80'026'361'856 bytes
Device is: In smartctl database [for details use: -P show]
ATA Version is: 6
ATA Standard is: ATA/ATAPI-6 T13 1410D revision 3a
Local Time is: Sat Jan 17 09:42:02 2009 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 645) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 55) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 062 Pre-fail Always - 0
2 Throughput_Performance 0x0005 105 105 040 Pre-fail Offline - 4582
3 Spin_Up_Time 0x0007 217 217 033 Pre-fail Always - 2
4 Start_Stop_Count 0x0012 097 097 000 Old_age Always - 6032
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 126 126 040 Pre-fail Offline - 37
9 Power_On_Hours 0x0012 073 073 000 Old_age Always - 11879
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 098 098 000 Old_age Always - 4059
191 G-Sense_Error_Rate 0x000a 099 099 000 Old_age Always - 65538
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 158
193 Load_Cycle_Count 0x0012 077 077 000 Old_age Always - 232158
194 Temperature_Celsius 0x0002 119 119 000 Old_age Always - 46 (Lifetime Min/Max 4/2286)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 16
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 11355 -
Warning! SMART Selective Self-Test Log Structure error: invalid SMART checksum.
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
shogun2:~# 
