Ich habe ein Zotac GTX 560 mit "GB VRam eingebaut und der kernel bringt mir ne fehlermeldung und friert dann ein. Was kann ich da machen damit das nouveau modul läuft?
Code: Alles auswählen
[ 8.379902] [drm] Initialized drm 1.1.0 20060810
[ 8.393686] snd_hda_intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
[ 8.393730] snd_hda_intel 0000:00:1b.0: irq 71 for MSI/MSI-X
[ 8.393748] snd_hda_intel 0000:00:1b.0: setting latency timer to 64
[ 8.403776] Error: Driver 'pcspkr' is already registered, aborting...
[ 8.416745] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
[ 8.421620] flexcop-pci: will use the HW PID filter.
[ 8.421622] flexcop-pci: card revision 2
[ 8.421627] b2c2_flexcop_pci 0000:07:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 8.433956] DVB: registering new adapter (FlexCop Digital TV device)
[ 8.436032] b2c2-flexcop: MAC address = 00:d0:d7:13:9d:40
[ 8.472717] b2c2-flexcop: ISL6421 successfully attached
[ 8.553100] MXM: GUID detected in BIOS
[ 8.553132] nouveau 0000:02:00.0: PCI INT A -> GSI 24 (level, low) -> IRQ 24
[ 8.553136] nouveau 0000:02:00.0: setting latency timer to 64
[ 8.553977] [drm] nouveau 0000:02:00.0: Detected an NVc0 generation card (0x0ce080a1)
[ 8.559044] [drm] nouveau 0000:02:00.0: Attempting to load BIOS image from PRAMIN
[ 8.574299] ITD1000: successfully identified (ID: 0)
[ 8.600796] b2c2-flexcop: ITD1000 successfully attached
[ 8.600798] b2c2-flexcop: found 'Samsung S5H1420/PnpNetwork PN1010 DVB-S' .
[ 8.600801] DVB: registering adapter 0 frontend 0 (Samsung S5H1420/PnpNetwork PN1010 DVB-S)...
[ 8.600911] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S rev 2.7a/u' at the 'PCI' bus controlled by a 'FlexCopIIb' complete
[ 8.664212] [drm] nouveau 0000:02:00.0: ... appears to be valid
[ 8.664215] [drm] nouveau 0000:02:00.0: BIT BIOS found
[ 8.664217] [drm] nouveau 0000:02:00.0: Bios version 70.24.2d.00
[ 8.664219] [drm] nouveau 0000:02:00.0: TMDS table version 2.0
[ 8.664220] [drm] nouveau 0000:02:00.0: Found Display Configuration Block version 4.0
[ 8.664223] [drm] nouveau 0000:02:00.0: Raw DCB entry 0: 04000310 00000000
[ 8.664224] [drm] nouveau 0000:02:00.0: Raw DCB entry 1: 01000312 00020030
[ 8.664226] [drm] nouveau 0000:02:00.0: Raw DCB entry 2: 02011380 00000000
[ 8.664228] [drm] nouveau 0000:02:00.0: Raw DCB entry 3: 08011382 00020030
[ 8.664229] [drm] nouveau 0000:02:00.0: Raw DCB entry 4: 02022362 00020010
[ 8.664231] [drm] nouveau 0000:02:00.0: Raw DCB entry 5: 040333b6 0f200010
[ 8.664233] [drm] nouveau 0000:02:00.0: Raw DCB entry 6: 04033372 00020010
[ 8.664235] [drm] nouveau 0000:02:00.0: DCB connector table: VHER 0x40 5 16 4
[ 8.664237] [drm] nouveau 0000:02:00.0: 0: 0x00001030: type 0x30 idx 0 tag 0x07
[ 8.664239] [drm] nouveau 0000:02:00.0: 1: 0x00010130: type 0x30 idx 1 tag 0x51
[ 8.664241] [drm] nouveau 0000:02:00.0: 2: 0x00002261: type 0x61 idx 2 tag 0x08
[ 8.664243] [drm] nouveau 0000:02:00.0: 3: 0x00220346: type 0x46 idx 3 tag 0x52
[ 8.664247] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table 0 at offset 0x6EB0
[ 8.684210] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table 1 at offset 0x75B0
[ 8.688883] [drm] nouveau 0000:02:00.0: unknown i2c port 51
[ 8.688938] [drm] nouveau 0000:02:00.0: 0x8A2D: Failed parsing init table opcode: INIT_I2C_LONG_IF -19
[ 8.689002] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table 2 at offset 0x8C88
[ 8.689004] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table 3 at offset 0x8C92
[ 8.689060] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table 4 at offset 0x8E71
[ 8.689062] [drm] nouveau 0000:02:00.0: Parsing VBIOS init table at offset 0x8ED6
[ 8.708880] [drm] nouveau 0000:02:00.0: 0x8ED6: Condition still not met after 20ms, skipping following opcodes
[ 8.708945] [drm] nouveau 0000:02:00.0: unknown i2c port 51
[ 8.709000] [drm] nouveau 0000:02:00.0: 3 available performance level(s)
[ 8.709003] [drm] nouveau 0000:02:00.0: 0: core 50MHz shader 101MHz memory 135MHz timing 5 voltage 950mV
[ 8.709007] [drm] nouveau 0000:02:00.0: 1: core 405MHz shader 810MHz memory 324MHz timing 4 voltage 950mV
[ 8.709011] [drm] nouveau 0000:02:00.0: 3: core 820MHz shader 1640MHz memory 2004MHz timing 3 voltage 962mV-1050mV
[ 8.709095] [drm] nouveau 0000:02:00.0: c: core 50MHz shader 101MHz memory 135MHz voltage 950mV
[ 8.717909] [TTM] Zone kernel: Available graphics memory: 3060906 kiB.
[ 8.717912] [TTM] Zone dma32: Available graphics memory: 2097152 kiB.
[ 8.717915] [TTM] Initializing pool allocator.
[ 8.717928] [drm] nouveau 0000:02:00.0: Detected 2048MiB VRAM
[ 8.717935] mtrr: type mismatch for d8000000,8000000 old: write-back new: write-combining
[ 8.717949] [drm] nouveau 0000:02:00.0: 512 MiB GART (aperture)
[ 8.816926] hda_codec: AD1989B: BIOS auto-probing.
[ 8.816986] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input5
[ 8.831073] [drm] Supports vblank timestamp caching Rev 1 (10.10.2010).
[ 8.831075] [drm] No driver support for vblank timestamp query.
[ 8.831088] [drm] nouveau 0000:02:00.0: unknown i2c port 49
[ 8.831147] [drm] nouveau 0000:02:00.0: unknown i2c port 49
[ 8.875798] [drm] nouveau 0000:02:00.0: unknown i2c port 56
[ 8.875856] [drm] nouveau 0000:02:00.0: unknown i2c port 56
[ 8.920502] [drm] nouveau 0000:02:00.0: unknown i2c port 54
[ 8.920598] [drm] nouveau 0000:02:00.0: unknown i2c port 55
[ 8.920653] No connectors reported connected with modes
[ 8.920655] [drm] Cannot find any crtc or sizes - going 1024x768
[ 8.921932] [drm] nouveau 0000:02:00.0: allocated 1024x768 fb: 0x1c0000, bo ffff8801b460c000
[ 8.922109] fbcon: nouveaufb (fb0) is primary device
[ 8.932104] Console: switching to colour frame buffer device 128x48
[ 8.936535] fb0: nouveaufb frame buffer device
[ 8.936536] drm: registered panic notifier
[ 8.936541] [drm] Initialized nouveau 0.0.16 20090420 for 0000:02:00.0 on minor 0
[ 8.936621] snd_hda_intel 0000:02:00.1: PCI INT B -> GSI 34 (level, low) -> IRQ 34
[ 8.936625] hda_intel: Disabling MSI
[ 8.936674] snd_hda_intel 0000:02:00.1: setting latency timer to 64
[ 9.756021] HDMI status: Codec=0 Pin=5 Presence_Detect=0 ELD_Valid=0
[ 9.787973] HDMI status: Codec=1 Pin=5 Presence_Detect=0 ELD_Valid=0
[ 9.819929] HDMI status: Codec=2 Pin=5 Presence_Detect=0 ELD_Valid=0
[ 9.851889] HDMI status: Codec=3 Pin=5 Presence_Detect=0 ELD_Valid=0
[ 9.867958] input: HDA NVidia HDMI/DP,pcm=9 as /devices/pci0000:00/0000:00:03.0/0000:02:00.1/sound/card1/input6
[ 9.868156] input: HDA NVidia HDMI/DP,pcm=8 as /devices/pci0000:00/0000:00:03.0/0000:02:00.1/sound/card1/input7
[ 9.868301] input: HDA NVidia HDMI/DP,pcm=7 as /devices/pci0000:00/0000:00:03.0/0000:02:00.1/sound/card1/input8
[ 9.868422] input: HDA NVidia HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:03.0/0000:02:00.1/sound/card1/input9
[ 10.850198] Adding 12564476k swap on /dev/sda5. Priority:-1 extents:1 across:12564476k
[ 10.863894] EXT4-fs (sda1): re-mounted. Opts: (null)
[ 11.016205] EXT4-fs (sda1): re-mounted. Opts: errors=remount-ro
[ 11.146879] loop: module loaded
[ 11.999430] RPC: Registered named UNIX socket transport module.
[ 11.999432] RPC: Registered udp transport module.
[ 11.999433] RPC: Registered tcp transport module.
[ 11.999434] RPC: Registered tcp NFSv4.1 backchannel transport module.
[ 12.062490] FS-Cache: Loaded
[ 12.124575] FS-Cache: Netfs 'nfs' registered for caching
[ 12.133297] Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
[ 12.164276] input: PS/2 Generic Mouse as /devices/platform/i8042/serio1/input/input10
[ 12.509739] sky2 0000:05:00.0: eth0: enabling interface
[ 12.510333] ADDRCONF(NETDEV_UP): eth0: link is not ready
