ich habe einen Daemon gestartet. Jedoch wird keine Datei mit PID in /var/run erzeugt. Irgendwo stecke ich da, kann mir jemand einen Tipp geben?
Code: Alles auswählen
#! /bin/sh
# Kommentar ...
set -e
PATH=/usr/local/sbin:/usr/local/bin:/sbin:/bin:/usr/sbin:/usr/bin
DESC="swatch"
NAME=swatch
DAEMON=/usr/local/bin/$NAME
PIDFILE=/var/run/$NAME.pid
SCRIPTNAME=/etc/init.d/$NAME
# Gracefully exit if the package has been removed.
SWATCH_BIN=/usr/local/bin/swatch
test -x $SWATCH_BIN || { echo "$SWATCH_BIN not installed";
if [ "$1" = "stop" ]; then exit 0;
else exit 5; fi; }
# Check for existence of needed config file and read it
SWATCH_CONFIG_D=/etc/swatch/swatch.conf.d
test -r $SWATCH_CONFIG_D || { echo "$SWATCH_CONFIG_D not existing";
if [ "$1" = "stop" ]; then exit 0;
else exit 6; fi; }
# Read config
. $SWATCH_CONFIG_D
# Check for existence of needed config file and read it
SWATCH_CONFIG=/etc/swatch/swatch.conf
test -r $SWATCH_CONFIG || { echo "$SWATCH_CONFIG not existing";
if [ "$1" = "stop" ]; then exit 0;
else exit 6; fi; }
SWATCH_OPT="--tail-file=$SWATCH_TAILFILE --config-file=$SWATCH_CONFIG --daemon"
#
# Function that starts the daemon/service.
#
d_start() {
start-stop-daemon --start --quiet --pidfile $PIDFILE \
--exec $DAEMON -- $SWATCH_OPT
}
#
# Function that stops the daemon/service.
#
d_stop() {
start-stop-daemon --stop --quiet --pidfile $PIDFILE \
--name $NAME
}
#
# Function that sends a SIGHUP to the daemon/service.
#
d_reload() {
start-stop-daemon --stop --quiet --pidfile $PIDFILE \
--name $NAME --signal 1
}
case "$1" in
start)
echo -n "Starting $DESC: $NAME"
d_start
echo "."
;;
stop)
echo -n "Stopping $DESC: $NAME"
d_stop
echo "."
;;
#reload)
#
# If the daemon can reload its configuration without
# restarting (for example, when it is sent a SIGHUP),
# then implement that here.
#
# If the daemon responds to changes in its config file
# directly anyway, make this an "exit 0".
#
# echo -n "Reloading $DESC configuration..."
# d_reload
# echo "done."
#;;
restart|force-reload)
#
# If the "reload" option is implemented, move the "force-reload"
# option to the "reload" entry above. If not, "force-reload" is
# just the same as "restart".
#
echo -n "Restarting $DESC: $NAME"
d_stop
sleep 1
d_start
echo "."
;;
*)
# echo "Usage: $SCRIPTNAME {start|stop|restart|reload|force-reload}" >&2
echo "Usage: $SCRIPTNAME {start|stop|restart|force-reload}" >&2
exit 1
;;
esac
exit 0
Chris