ich kriege wpa mit meinem ibm und dem speedtouch nicht zu laufen. die karte läuft unter wep und open wlan super. es will einfach nur wpa nicht laufen.
wpa_supplicant.conf
Code: Alles auswählen
ctrl_interface=/var/run/wpa_supplicant
ctrl_interface_group=0
ap_scan=1
network={
scan_ssid=1
ssid="linux"
key_mgmt=WPA-PSK
pairwise=CCMP TKIP
group=CCMP TKIP WEP104 WEP40
psk="66666666"
priority=2
}
Code: Alles auswählen
[wireless secmode]=>config
Security level WPA-PSK:
preshared key : 66666666
encryption : TKIP
rekeying : every 60 seconds
[wireless secmode]=>
Code: Alles auswählen
Initializing interface 'eth0' conf 'wpa' driver 'ipw' ctrl_interface 'N/A'
Configuration file 'wpa' -> '/home/dark/wpa'
Reading configuration file '/home/dark/wpa'
ctrl_interface='/var/run/wpa_supplicant'
ctrl_interface_group=0
ap_scan=1
Priority group 2
id=0 ssid='linux'
Initializing interface (2) 'eth0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_ipw_init is called
SIOCGIWRANGE: too old (short) data - assuming WPA is not supported
Own MAC address: 00:12:f0:00:29:a5
wpa_driver_ipw_set_wpa: enabled=1
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_countermeasures: enabled=0
wpa_driver_ipw_set_drop_unencrypted: enabled=1
Setting scan request: 0 sec 100000 usec
Added interface eth0
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth0' added
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth0' added
State: DISCONNECTED -> SCANNING
Starting AP scan (specific SSID)
Scan SSID - hexdump_ascii(len=5):
6c 69 6e 75 78 linux
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
Added BSSID 00:00:00:00:00:00 into blacklist
State: SCANNING -> DISCONNECTED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
Scan timeout - try to get results
Received 476 bytes of scan results (2 BSSes)
Scan results: 2
Selecting BSS from priority group 2
0: 00:90:96:cf:49:4b ssid='linux' wpa_ie_len=24 rsn_ie_len=0 caps=0x11
selected based on WPA IE
Trying to associate with 00:90:96:cf:49:4b (SSID='linux' freq=0 MHz)
Cancelling scan request
WPA: clearing own WPA/RSN IE
Automatic auth_alg selection: 0x1
wpa_driver_ipw_set_auth_alg: auth_alg=0x1
WPA: using IEEE 802.11i/D3.0
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 2
WPA: set AP WPA IE - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: clearing AP RSN IE
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT WPA-PSK
WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
No keys have been configured - skip key clearing
wpa_driver_ipw_set_drop_unencrypted: enabled=1
State: DISCONNECTED -> ASSOCIATING
Setting authentication timeout: 5 sec 0 usec
EAPOL: External notification - EAP success=0
EAPOL: External notification - EAP fail=0
EAPOL: External notification - portControl=Auto
Wireless event: cmd=0x8b1a len=18
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:90:96:cf:49:4b
State: ASSOCIATING -> ASSOCIATED
Associated to a new BSS: BSSID=00:90:96:cf:49:4b
No keys have been configured - skip key clearing
Associated with 00:90:96:cf:49:4b
WPA: Association event - clear replay counter
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
EAPOL: External notification - portEnabled=1
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: SUPP_BE entering state IDLE
EAP: EAP entering state INITIALIZE
EAP: EAP entering state IDLE
Setting authentication timeout: 10 sec 0 usec
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth0' added
RX EAPOL from 00:0e:50:27:78:5a
Setting authentication timeout: 10 sec 0 usec
IEEE 802.1X RX: version=1 type=3 length=95
EAPOL-Key type=254
State: ASSOCIATED -> 4WAY_HANDSHAKE
WPA: RX message 1 of 4-Way Handshake from 00:0e:50:27:78:5a (ver=1)
WPA: WPA IE for msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: Renewed SNonce - hexdump(len=32): d1 48 a4 32 77 14 e5 71 d7 6e 8d b9 c4 41 25 ce e3 04 c3 8f 28 85 7f a4 52 37 35 09 de 3f 56 b3
WPA: PMK - hexdump(len=32): [REMOVED]
WPA: PTK - hexdump(len=64): [REMOVED]
WPA: Sending EAPOL-Key 2/4
RX EAPOL from 00:0e:50:27:78:5a
IEEE 802.1X RX: version=1 type=3 length=95
EAPOL-Key type=254
State: 4WAY_HANDSHAKE -> 4WAY_HANDSHAKE
WPA: RX message 1 of 4-Way Handshake from 00:0e:50:27:78:5a (ver=1)
WPA: WPA IE for msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: PMK - hexdump(len=32): [REMOVED]
WPA: PTK - hexdump(len=64): [REMOVED]
WPA: Sending EAPOL-Key 2/4
EAPOL: startWhen --> 0
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: txStart
WPA: drop TX EAPOL in non-IEEE 802.1X mode (type=1 len=0)
RX EAPOL from 00:0e:50:27:78:5a
IEEE 802.1X RX: version=1 type=3 length=95
EAPOL-Key type=254
State: 4WAY_HANDSHAKE -> 4WAY_HANDSHAKE
WPA: RX message 1 of 4-Way Handshake from 00:0e:50:27:78:5a (ver=1)
WPA: WPA IE for msg 2/4 - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 02 01 00 00 50 f2 02 01 00 00 50 f2 02
WPA: PMK - hexdump(len=32): [REMOVED]
WPA: PTK - hexdump(len=64): [REMOVED]
WPA: Sending EAPOL-Key 2/4
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
WPA: 4-Way Handshake failed - pre-shared key may be incorrect
Setting scan request: 0 sec 100000 usec
Added BSSID 00:90:96:cf:49:4b into blacklist
State: 4WAY_HANDSHAKE -> DISCONNECTED
EAPOL: External notification - portEnabled=0
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth0' added
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
BSSID 00:00:00:00:00:00 blacklist count incremented to 2
State: DISCONNECTED -> DISCONNECTED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Code: Alles auswählen
NAS: sending packet through wl0 eapol socket 33
0:00:00.00 - BRIDGE-TRAP: Port 6 changed state from BROKEN to FORWARD.
NAS: sending packet through wl0 eapol socket 33
NAS: recv'd wl0 eapol packet
NAS eapol_dispatch():type 3 msg from 00:12:f0:00:29:a5
NAS: sending packet through wl0 eapol socket 33
NAS: recv'd wl0 eapol packet
NAS eapol_dispatch():type 3 msg from 00:12:f0:00:29:a5
NAS: sending packet through wl0 eapol socket 33
NAS: recv'd wl0 eapol packet
NAS eapol_dispatch():type 3 msg from 00:12:f0:00:29:a5
NAS toss_sta(): deauthenticating: 00:12:f0:00:29:a5
0:00:00.00 - BRIDGE-TRAP: Port 6 changed state from FORWARD to BROKEN.
vielleicht habe ich ja noch ein problem auf anderer ebene, nur leider kann ich dazu im log nichts erkennen.
gruss dark
