ich habe anscheinend ein Problem mit dem Treiber der Netzwerkkarte. Ich bekomme einfach das Full Duplex nicht ans laufen.
Laut mii-tool sollte der full duplex laufen
Code: Alles auswählen
R21778:~# mii-tool -v
eth0: 100 Mbit, full duplex, link ok
product info: vendor 00:00:00, model 0 rev 0
basic mode: 100 Mbit, full duplex
basic status: link ok
capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
Code: Alles auswählen
R21778:~# ./rtl8139-diag -m
rtl8139-diag.c:v2.13 2/28/2005 Donald Becker (becker@scyld.com)
http://www.scyld.com/diag/index.html
Index #1: Found a RealTek RTL8139 adapter at 0xb800.
Realtek station address 00:0b:6a:8d:f4:a3, chip type 'rtl8139C+'.
Receiver configuration: Normal unicast and hashed multicast
Rx FIFO threshold 2048 bytes, maximum burst 2048 bytes, 32KB ring
Transmitter enabled with NONSTANDARD! settings, maximum burst 1024 bytes.
Flow control: Tx disabled Rx disabled.
The chip configuration is 0x10 0xad, MII half-duplex mode.
No interrupt sources are pending.
The RTL8139 does not use a MII transceiver.
It does have internal MII-compatible registers:
Basic mode control register 0x2100.
Basic mode status register 0x780d.
Autonegotiation Advertisement 0x01e1.
Link Partner Ability register 0x0000.
Autonegotiation expansion 0x0000.
Disconnects 0x0000.
False carrier sense counter 0x0000.
NWay test register 0x0300.
Receive frame error count 0x0000.