Karte: Enerasys Orinoco Gold
Kernel: 2.6.11 + Patch ( http://www.kismetwireless.net/download. ... rinoco2611 )
Code: Alles auswählen
eth3: Station identity 001f:0001:0006:0004
eth3: Looks like a Lucent/Agere firmware version 6.04
eth3: Ad-hoc demo mode supported
eth3: WEP supported, 104-bit key
eth3: MAC address 00:E0:63:82:B2:C9
eth3: Station name "HERMES I"
eth3: ready
eth3: index 0x01: Vcc 5.0, irq 5, io 0x0100-0x013f
Code: Alles auswählen
iwconfig eth3
eth3 IEEE 802.11-DS ESSID:"" Nickname:"HERMES I"
Mode:Managed Frequency:2.422 GHz Access Point: 00:00:00:00:00:00
Bit Rate:11 Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/92 Signal level=134/153 Noise level=134/153
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Code: Alles auswählen
iwpriv eth3
eth3 Available private ioctl :
force_reset (8BE0) : set 0 & get 0
card_reset (8BE1) : set 0 & get 0
set_port3 (8BE2) : set 1 int & get 0
get_port3 (8BE3) : set 0 & get 1 int
set_preamble (8BE4) : set 1 int & get 0
get_preamble (8BE5) : set 0 & get 1 int
set_ibssport (8BE6) : set 1 int & get 0
get_ibssport (8BE7) : set 0 & get 1 int
monitor (8BE8) : set 2 int & get 0
dump_recs (8BFF) : set 0 & get 0
Code: Alles auswählen
iwconfig eth3 mode monitor
Error for wireless request "Set Mode" (8B06) :
SET failed on device eth3 ; Invalid argument.