Also, ich habe mir das mal angesehen und ich sehe mich leider bestätigt.
Ich habe auch schon Kabel und switch ausgetauscht, nichts gebracht.
Kann es sein, dass die Platte das nicht bringt, weil die in PIO läuft?
Code: Alles auswählen
PDC20269: IDE controller at PCI slot 0000:00:07.0
PDC20269: chipset revision 2
PDC20269: ROM enabled at 0xdffe0000
PDC20269: 100% native mode on irq 18
ide2: BM-DMA at 0xdc00-0xdc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xdc08-0xdc0f, BIOS settings: hdg:pio, hdh:pio
hde: Maxtor 6Y160P0, ATA DISK drive
ide2 at 0xec00-0xec07,0xe802 on irq 18
hde: max request size: 1024KiB
hde: 320173056 sectors (163928 MB) w/7936KiB Cache, CHS=19929/255/63, UDMA(133)
hde: hde1 hde2 < hde5 hde6 >
Allerdings wird sie ja als UDMA133 erkannt, aber bei meiner anderen Platte steht auch DMA:
Code: Alles auswählen
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci0000:00:11.1
ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:DMA
Könnte das mal bitte jemand für mich deuten?
Thanx,
ZOiD