Ich habe mir einen Dedicated Server bei OVH gemietet und bekomme leider die 6 Failover-IPs in Proxmox "installiert".
Mein Ziel ist es die 6 IPv4's für 6 VM's zu benutzen, doch bekomme die /etc/network/interfaces Datei nicht richtig eingestellt
Könnte mir irgendwer helfen?
Die frisch ausgesetzte Config sieht so aus
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# for Routing
auto vmbr1
iface vmbr1 inet manual
post-up /etc/pve/kvm-networking.sh
bridge_ports dummy0
bridge_stp off
bridge_fd 0
# vmbr0: Bridging. Make sure to use only MAC adresses that were assigned to you.
auto vmbr0
iface vmbr0 inet static
address 37.59.14.xxx
netmask 255.255.255.0
network 37.59.14.0
broadcast 37.59.14.255
gateway 37.59.14.xxx
bridge_ports eth0
bridge_stp off
bridge_fd 0
iface vmbr0 inet6 static
address 2001:41d0:8:6171::
netmask 64
post-up /sbin/ip -f inet6 route add 2001:41d0:8:61ff:ff:ff:ff:ff dev vm$
post-up /sbin/ip -f inet6 route add default via 2001:41d0:8:61ff:ff:ff:$
pre-down /sbin/ip -f inet6 route del default via 2001:41d0:8:61ff:ff:ff$
pre-down /sbin/ip -f inet6 route del 2001:41d0:8:61ff:ff:ff:ff:ff dev v$